Nexa LDR-1303, Dimmer for Jolly Maxi, 1-10V

manufacturer image
Produktet eksisterer ikke, eller er ikke lenger tilgjengelig for salg.

Varenummer : 14316
Prod/lev varenr : GT-791
EAN : 7330545143164
Fraktvekt : 0,5 kg

NEXA LDR-1303 Dimmer for Jolly Maxi with 0-10 V output for controlling units that has 1-10V interface, white

1-10V is standard for analog control that is implemented in many LED actuators but it also exists in other applications such as fan-engines for ventilation.

< 1V is off, 1V is the lowest value and 10V is the highets. It is the actuator that decides how the value is interpreted and translates to brightness. A linear guidance signal doesn't mean a linear dimming. When OFF is sent to LDR-1303, the actuator lowers the value towards 0V, Depending on how the actuator is constructed, the LEDs can continue to glow for a short while after having received the value OFF. It is the properties of the actuator that decides if the light turns off immediately or not. The LDR-1303 os drovem wotj 12-24V via the actuator in those cases where an AUX-output is available or via an external transformator. It must NOT be connected to 230V. LDR-1303 is compatible with all self learning transmitters in System Nexa.

Settings for lower dimming level:
Turn your lamp on with the remote.
Press two times in a quick manner on the receivers learning-button. The diode should now bling rappidly and the receiver is in programming mode.
Press the ON-button one time and the lamp will immediately go to a new lowest level, when the ON-button is pressed again, the receiver goes to an even higher dimming level. This is repeated three times until you have found the optimal lower wimming level. What you want to achieve is a low level as you can without the lamp turning completely off or flickering. Should the lamp flicker at a very low dimming level, just press the OFF-button and the dimmer turns up to a new level (there are a total of four different levels).
When you are satisfied with the lowest dimming level, press the learning button fast two times to save the setting, the diode should now stop to blink.

Specifications:
. Drive Voltage: 12-24 V
. Frequency: 433,92 MHz
. Memory slots: 10
. Power consumption on standby: 30mA

Dimensions(WxDxH): 44x40x22mm



Bredde4.4 cm
Dybde4 cm
Frekvensområde433.92 MHz
FunksjonerPasser for 1-10 V LED-lys
Høyde2.2 cm
Nominell spenningDC 12 - 24 V
OverføringsteknologiTrådløs
ProdukttypeDimmer
Strømforbruk ved drift0.5 watt




Alle priser ink. mva. Frakt er ikke inkludert. Se frakteksempler i handlekurven.
Bytte til eks. mva

Copyright 2007-2021 - Yaha AS - All rights reserved